Our products

Threading of 1/8" bore drive dog propeller

Brass reducer to insert into 3/16" bore prop hub to go onto 4mm shaft.

The OCTURA® balancer consists of an extruded ali base incorporating two parallel steel rods for the prop balancing rod to roll on. There is a levelling screw in the base and three imperial size rods for the props. 1/8", 3/16" and 1/4", which are stored in the base body, plus instructions

Y531 has 10% more pitch than the X431. Bore is 1/8" which can be opened to 4mm. or can be threaded 4mm. The material for this prop is remarkable strong

Y5 series prop which has 10% more pitch than X4 series. This drive dog prop has a 1/8" bore and can be threaded 4mm if required.

This prop has a 1/8" bore and can be threaded 4mm.  10% more pitch than the X435. Use when your running out of top end speed with your X435.

 37mm diam. with 10% more pitch that an X437/3 prop"

The same blade profile as the X4 series props but has 10% more pitch than the X447. Good for high powered 7.5cc motors.

X447 pitch is 2.59"
Y547 pitch is 2.85"

Ideal replacement for your X457, when your engine can't quite drive an X460. Great on a 15cc mono and cats."

72mm dia. x 110.9mm pitch.  For use on the higher torque twin inline 26cc + motors using surface drive on Monos,  Hydros & cats. A good prop for 30-35cc motors."

Balance and polish 2 blade props 67mm and to 82mm.

Balancing & polishing 2 blade silicon bronze props from 40mm up to 82mm

Balance and Polish 3 blade props 35mm up to 50mm

Balance & polish 3 blade props

OC4MM2187 Adapter 4mm to 3/16" shaft. Fits ont a 4mm shft to allow the use of props with a 3/16" bore